|
CLOTHREYES TUTORIAL Part 4 -- Collar by Dollpartz PAGE 3 1,2,3,4,5,6,7 |
|
| Collar--increase polys around neck | ||
|
Extrude four times, and draw it over the arm again. When we were originally creating the shirt, joining front and back shoulders by extrusion, we could have done extruded this many times! We only extruded twice back then. However, this does serve to illustrate how you can make amends in progress ... I'm sure not going back now! :) |
||
 |
||
|
Switch to sub-object vertices, line up the seams, cuz you'll be re-joining them: |
||
 |
||
| I suggest joining seams a pair of vertices at a time, 18 pairs total (collapse button as before). Somewhere along the way, you may wanna set shirt transparent (right click on shirt, select properties, check 'see through') to join pairs in the tuck inside top of the arm: | ||
 |
||
|
Voila, we have more polys at the side of neck ... In total, we've gone from a measly 12 edges around the whole neck to 22 edges! This'll make the collar much rounder looking when we extrude it out (Meshsmooth applied at the very end of the process'll make it just that bit more round). |
||
 |
||
| Extruding collar next. | ||
|
|
||
|
|
||